Chassis Straightening

A bent chassis affects more than looks — it can throw out wheel alignment, handling and safety. Using a measured chassis jig system, we pull panels and frame rails back to factory tolerances, checking measurements at every stage so the structure is genuinely straight, not just close.

Why Choose Karbase Services

• Computer-measured chassis jig for factory-accurate results
• Corrects frame rail, floor pan and structural misalignment
• Restores proper wheel alignment and handling after impact
• Before-and-after measurement reports available
• Works alongside our collision repair service for full restoration

Our Process

1. Measure — Chassis is measured against factory specifications on the jig.
2. Pull & Correct — Controlled hydraulic pulls bring panels back into tolerance.
3. Re-Measure — Structure is re-checked against spec at each stage.
4. Sign Off — Final measurement report confirms the chassis is within tolerance.

Suspect frame damage after an impact? Book a chassis measurement check.